DIST: Markov chain sampling for a specified distribution. The 'dist' programs allow you to specify a distribution by giving an "energy" function (minus the log of the density, plus an arbitrary constant), and to then generate a sample from this distribution using the various Markov chain methods. These programs are primarily intended for use in demonstrating the Markov chain methods; using these programs to sample from many of the distributions encountered in real Bayesian inference problems would be tedious or impossible. However, the C source for the 'dist' programs, as well that for the demo for a bivariate Gaussian (see bvg.doc), does illustrate how to interface to the generic Markov chain routines, in order to write a suite of programs for some new application. The code for this in the 'dist' and 'bvg' programs is perhaps more easily understood than the more complex code in the 'net', 'gp', and 'mix' programs. The distribution is specified using the dist-spec program (see dist-spec.doc). An initial state for the Markov chain can then be specified (see dist-initial.doc). The Markov chain operations to use should then be specified (see mc-spec.doc), after which the Markov chain is run using dist-mc (see dist-mc.doc). The resulting states can be printed (see dist-display.doc), or the values of selected state variables can be plotted (see xxx-plt.doc and dist-quantities.doc). Note that values for the energy function, and its gradient if required, are calculated by an interpreter written in C, which is considerably slower than compiled C code. The compute time required to sample from a distribution using the 'dist' programs will therefore be greater than would be required using a specially-written module. Copyright (c) 1998 by Radford M. Neal